• Follow us
Home > Exhibition > Content

Contact us

JINAN LIN SHUN CNC MECHANICAL EQUIPMENT CO., LTD
You can submit Orders online, provide feedback, or call our telephone directly;
ADD: No.18, Xiaozhangma Industry Zone, Industry North Road Lichen District, Jinan
TEL: +86 0531-88267066
FAX: +86 0531-88267877
WhatsApp: +86 13589042005
Email: michael@cncrouter.cc
Daily maintenance of engraving machine
May 03, 2018

1. Continuous operation time is less than 10 hours per day to ensure the cleanliness of the cooling water and the normal operation of the water pump. The water spindle motor must not be exposed to water shortage. Replace the cooling water regularly to prevent the water temperature from being too high. In winter, if the working environment is too cold, replace the water in the tank with antifreeze.


2. Every time the machine is used, it is necessary to pay attention to cleaning, be sure to clean the dust on the platform and drive system, and regularly (weekly) lubrication of the drive system (X, Y, Z triaxial). (Note: X, Y, Z three-axis light rods are maintained with motor oil; high-speed butter is added to the screw rods; if the working ambient temperature is too low in winter, PRTT ball screws and light rods (square rails or circular guide rails) should be used with gasoline first. Rinse and clean, then add oil, otherwise it will cause the resistance of the machine's transmission part to be too large and cause the machine to misalign.)


3. When performing electrical maintenance inspections, be sure to turn off the power and wait until the monitor has no display and the main circuit power indicator is off.


4. The engraving machine must be inspected for fasteners for about three months. The connection screws on both sides of the gantry, the fastening screws of the screw nut, and the fastening screws on both sides of the gantry are used for fastening.