• Follow us
Home > News > Content

Contact us

You can submit Orders online, provide feedback, or call our telephone directly;
ADD: No.18, Xiaozhangma Industry Zone, Industry North Road Lichen District, Jinan
TEL: +86 0531-88267066
FAX: +86 0531-88267877
WhatsApp: +86 13589042005
Email: michael@cncrouter.cc
Engraving Machine Maintenance
Mar 04, 2016

Continuous running time below 10 hours a day, keep the water clean, and normal water pump work, spindle motor must not be water occurred water shortages regularly replace the cooling water to prevent the water temperature is too high. In winter if the operating temperature is too low the water tank with antifreeze.

Each time the machine after use, pay attention to clean, be sure to clean up the dust on the platforms and transmission systems, regular (weekly), the transmission system (x, y, z axes) lubricating oil. (Note: x, y, z axis light rod oil maintenance; screw part of the butter at high speed in winter if the operating temperature is too low, PRTT ball screw, Rod (square rails or circular rail) parts should first be washed clean with gasoline, then add oil, otherwise the machine will drive part of the resistance as a result of displacement of the machine. )

Appliance maintenance check, be sure to cut the power, nothing displayed on the monitor and the main circuit power supply led is off, can be carried out.

Engraving machine uses about three months to check your fasteners, gantry on both sides of the connecting screws, screw nut fastening screws, for fastening on both sides of the fastening screws of the motor.