• Follow us
Home > News > Content

Contact us

JINAN LIN SHUN CNC MECHANICAL EQUIPMENT CO., LTD
You can submit Orders online, provide feedback, or call our telephone directly;
ADD: No.18, Xiaozhangma Industry Zone, Industry North Road Lichen District, Jinan
TEL: +86 0531-88267066
FAX: +86 0531-88267877
WhatsApp: +86 13589042005
Email: michael@cncrouter.cc
Laser Machine Used In The Development Of Materials Is Very Wide
Oct 18, 2017

Laser machine used in the development of materials is very wide, suitable for double-sided adhesive, foam, dust, PVC, protective film, conductive cloth, and so on! For some die can not do special processing, such as small products, microporous, special shape, laser machine can also be achieved. This is a clever laser machine.

What are the problems in the actual operation?

1, cutting effect is not good or cut through:

Cause one: is the power setting, adjust the maximum and minimum light intensity, fine-tuning or below the end of paper for thicker; if the loose rail may also lead to power instability;

Cause two: is the optical path is partial, to fine-tune, or that you cut the speed too fast;

Cause three: the lens is dirty, to remove the use of alcohol and wipe with clean paper, pay attention to dismantling the lens, pay attention to protect the lens;

Reason four: is the focus lens installed anti, lens installed anti-lead to optical path deviation;

Reason five: is the focal length, if the cut out of the line is too large, it is necessary to adjust the laser head and material height;

Reason six: laser tube power attenuation, water temperature is too high, voltage instability and so on.

2, the connection is not on the device: the computer is installed driver, USB cable or cable is plugged in, check the USB cable or cable is damaged, Laser machine the adapter is rusted;

3, cut the graphics deformation and cutting overlap: check the rail is loose, the motor is bad, the voltage is stable, the machine's system settings have not changed;

4, the device can not start or open the gate will trip: check the emergency stop switch is pressed, whether the external access power is connected, Laser machine whether the outside world to hear the sound of abnormal snapping, the circuit is broken lead to trip will trip.

5, high-voltage line in the ignition: the problem should pay attention to, may be long-term use of the line, it is recommended in the high-voltage lines outside the high pressure insulation sleeve, in this case to power operation.

6, cut out the graphics size is too large or small: check the platform is flat and whether the material has been paved, so the cutting process to open the suction, the material sucked to straight;

7, cutting no light: the first check out the light switch is not bad, chillers are not open and return water is normal, Laser machine because now there are many protection devices, no cooling water will not light;

8, boot the rear panel no display: Laser machine check the boot switch is damaged, the switching power supply is normal, and then check the display panel is not bad or line jack is aging;

9, cutting the rail does not turn or movement weakness: check the motor is a problem, the driver has no problem, observe whether the rust or foreign body stuck;

10, the glass tube is not light: check the laser tube laser power supply water system and the light signal several aspects of the start, generally first direct observation of the laser power is normal power, the laser tube tube outside the tube is abnormal, whether the normal water cycle system, if not normal For the corresponding replacement or adjustment. This method can be a normal light that laser tube laser power failure, water protection switches, relays, door switches, board signals and other signal problems, Laser machine followed by the exclusion can be. If this method does not light the laser tube or laser power problems, in the case of bad judgment with the replacement method can be resolved.